Catena 4612/4611 User Manual
Engineering Report 234001173 Rev
A
- 10 -
Figure 7 ST Link Programmer
4.4.2
USB to Serial Cable
USB to Serial Cable (123001121) is used for Configuring the device with TTN and also for
monitoring the device performance on the Serial Monitor.
Figure 8 USB to Serial Cable
Note: The Serial cable configurations are mentioned in the Table 2
5
Software Requirements
To proceed with Catena 4612/4611 setup and test procedure, the below software tools are required.
Arduino IDE
for windows can be downloaded from below link:
o
https://www.arduino.cc/en/Main/Software
ST-Link Debugger driver
for windows can be downloaded from the link below:
o
https://www.st.com/en/development-tools/st-link-v2.html
USB to Serial converter
for windows
Zadig
tool is required for programming Catena 4612 the tool can be downloaded from the link
below:
o
Basic libraries required
o