Catena 4612/4611 User Manual
Engineering Report 234001173 Rev
A
- 11 -
o
o
o
o
o
o
o
6
Assembly Instructions
1)
Catena 4612/4611 board assembling procedures are listed below:
a.
Attach the 12-pin & 16-pin Male Headers on JP1 and JP2 of Catena 4612/4611 board
respectively.
i.
Solder one or two posts on each strip, to tack the header in place
ii.
Adjust the vertical and horizontal alignment
iii.
Solder the remaining posts for reliable electrical contact
b.
Trim excess length of the 16-pin header in the area of screw terminals.
c.
Solder the Whip antenna as per the Antenna Specification mentioned in Table 2.
d.
Attach the 1x04 Screw Terminals on JP3 and JP4 respectively.
i.
Solder one post
ii.
Adjust for proper alignment and good cosmetics
iii.
Solder the remaining posts
NOTE: Catena 4610 Base do not require male pin headers and screw terminals to be soldered (only
whip antenna is sufficient for base board). However, user can solder them based on their setup
requirement.
Figure 9 Catena 4612 after soldering components
e.
Connect the Battery to the X3 of the board.
