M300DP L Series Expansion I/O Module – Installation / User Manual
24
Copyright 2016 MBW Technologies, LLC All Rights Reserved
Default Settings
Upon receiving the Auto Start module, the unit will be set to the following
values. Setting the module back to defaults is made by using the
RESTORE DEFAULTS which is under the ENGINE SETTINGS menu
level.
Parameter
Default Value
Display Settings
M300 Mode
OFF
Speed 1
Engine Min RPM
Speed 2
1500 RPM
Speed 3
Engine Max RPM
Throttle Profile
Speed1 (s)
5
Speed1 Ramp (s)
5
Speed2 (s)
5
Speed2 Ramp (s)
5
Speed3 (s)
5
Stop (s)
5
DI1 Setup
OFF
DI2 Setup
OFF
AI1 OFF
AI2 OFF
A/S Delay (s)
10
Start Retries
0
M300DP L Series Expansion I/O Module – Installation / User Manual
Copyright 2016 MBW Technologies, LLC All Rights Reserved
13
Speed Settings
The A/S Mode supports three different engine speed settings. These
settings can be used in the throttle profile and in the remote speed
assignments. The speed values (RPM) may be programmed from 600 to
3150 in increments of 50 RPMs. Speed 1, 2, and 3 are bounded by the
Engine MIN/MAX RPM range in the Engine menu.
(Note: range of rpm settings may vary based on engine model.)
Use the “
▼
” or “
▲
” keys to set the RPM for Speed 1, 2, and 3. Press and
hold
MODE
key to save each selection.
Throttle Profile
When the AutoStart input is activated, a Throttle Profile is used to control
the engine speed over a series of steps. The profile has 5 settings which
are described in Table 2 below. Use the “
▼
” or “
▲
” keys to set the
desired time for each stage of the Throttle Profile. Press and hold
MODE
key to save each selection.
Note: If a Throttle Profile Segment time is set to zero, that segment of the
profile will be skipped.
Table 2 - Throttle Profile Setup
Speed1 (s) – This parameter determines how many seconds the engine
will run at Speed1.
Ramp->Speed2 (s) – This parameter determines the ramp time from
engine Speed 1 to Speed 2 in seconds.
Speed2 (s) – This parameter determines how many seconds the engine
will run at Speed2.
Ramp->Speed3 (s) – This parameter determines the ramp time from
engine Speed 2 to Speed 3 in seconds.
Ramp->Min (s) – This parameter determines ramp time from current
speed to the Min RPM value in Engine menu.
