M300DP L Series Expansion I/O Module – Installation / User Manual
8
Copyright 2016 MBW Technologies, LLC All Rights Reserved
M300DP Module Setup
To access the M300DP menu, press on the
MODE
key to view the Main Menu. Press the “
▼
” or “
▲
”
keys until “M300DP Module” is highlighted. Press
and hold
MODE
> 1 second to enter the M300DP
submenu.
NOTE: The M300DP Module menu selection will only be visible if the
M300DP is correctly installed and has CANbus communication with the
M150L series display.
M300DP Modes
The M300DP has three modes which determine how the module operates
as well as the structure of the M300DP menu within the display.
OFF
: AutoStart functionality is disabled.
Configurable digital inputs are disabled. The two
additional analog inputs are still available and are
a shared setting between all three modes.
I/O
: Two configurable DI’s can be set as engine
stop, start, inhibit, or programmable speed
inputs. Analog inputs remain the same. No
autostart functionality.
A/S
: Autostart mode uses the DI’s to
automatically start and stop the engine while key
switch is in the “Auto” position. A customizable
three speed throttle profile controls the engine
speed during startup and shutdown.
To view the current
M300DP Mode, press and
hold the
MODE
key > 1
second while the MODE
selection is highlighted. To
change the mode, use the “
▼
” or “
▲
” keys to highlight the desired mode.
Press and hold the mode key to save and confirm the change.
M300DP L Series Expansion I/O Module – Installation / User Manual
Copyright 2016 MBW Technologies, LLC All Rights Reserved
29
Appendix B – Field Installation
Making the Connections
The Expansion I/O Module shown in Figure 1, has two floating connectors
(P4 and S1), 6 wire leads to be connected to the Engine connector, one
black lead with a piggyback quick disconnect which goes to the throttle
and two leads (Yellow and Green) which go to the .
Also provided are six 6” pig tails (White w/Blue, Orange, Green w/Black,
White, White w/Black and Black) which can be used on the engine side of
the engine connector to make remote connections to analog and discrete
inputs.
Recommended order
:
1. Verify the battery / battery switch connections to engine per the
engine installation diagram. (Refer to engine manufacturer
installation manual.). Verify engine is bonded to battery return (-).
Verify engine block is connected to battery ground.
2. Disconnect battery.
Control Panel Modifications
3. Loosen the four screws (3/32 Hex) and remove the control panel
from the housing base. Disconnect the control panel from the
engine harness (HDP24-21 connector).
4. Make connections from the Auto Start module to the display.
MORE DETAIL IN NEXT SECTION
5. Make connections from the Auto Start module to the keyswitch
6. Make a connection to the throttle switch
7. Insert the 6 wire leads from the Auto Start module into the 21 pin
engine connector (HDP24-21 connector).
Engine Harness Modifications
8. Make external connections to the Oil Pressure Sender, Fuel
Sender, Digital Input 1, Digital Input 2 and Common to the 21 pin
Deutsch connector of the engine harness using the five 6” pigtails.
