Alterations reserved
Operating Manual
SBAP 46/72/82-ME ENG
Stand 01/2004
Page 20
4.4.4
Transport tape at the collector table
The transport tape 43 at the collector
table may be tensioned on both sides.
For this purpose, loosen four screws 44
each on both sides and, upon loosening
the internally located nut 46,
unscrew the tensioning screw 45
counter-clockwise.
Make sure that the tape is equally
tensioned on both sides and does not
run off to the side.
Although the centre run is fixed laterally
through the disks 47, the tape should
not push too firm against the disks. After
you have completed the adjustments re-
fasten all screws and nuts.
4.4.5
Lower line-up tapes
The lower line-up tapes 48 are
completely tensioned through the tape
shaft 49.
For this purpose, loosen the screws 50
and the counter nuts 51.
Consequently, the tape shaft is
tensioned by a constant clockwise turn
of both nuts 52.
After you have completed the tensioning
re-fasten all screws and nuts.
