16
4. Power the product on and conduct a clinching trial to check the status of the staple. Repeat Step
3 until the staple is properly clinched.
After completion of the adjustment, refasten the hexagonal hole screws.
Note that fastening them too tightly can deform the metal plate.
5. After the adjustment, take the reverse steps to reassemble the product.
List of Components
No.
Name
Qty.
413
Reinforcement S
2
NC3x6
Washer-Equipped
Screw
(small)
8
M4x8
Small Pan Head Screw
6
HS4x12
Inner Hexagonal Hole Screw
2
3-9 Adjusting the Cushion Piece
1. Following the steps in
3-1 Replacing the Outer Covers
, remove the side cover L.
2. Unfasten four screws to remove the main unit bottom plate.
Adjusting the front-rear position of
the clincher piece
When the piece is closer to
the rear end
When the piece is closer to
the front end
When the piece is at the
correct position
Paper
Insertion
Direction
206 [Main Unit
Bottom Plate]
4-M4x8
