Mazda 6 2016, Manual

Page: 21 / 610

Black plate (21,1)
NOTE
l
Individual seat positions can be
programmed to the two available
programming buttons on the side of the
driver's seat, plus one seat position for each
registered key.
l
If the vehicle has been serviced and the
battery cables disconnected, the
programmed seat positions will have been
erased. Re-program the seat positions.
Programming
1. Switch the ignition OFF.
2. Adjust the seat to the desired position
using the slide lifter and reclining
switches.
Refer to Seat Operation on page 2-5.
3. Press the SET button on the seat until a
beep sound is heard one time.
4. Perform one of the following settings
within 5 seconds of completing step 3
above:
l
Programming to a button on the seat
side
Press the button you want to
program, either button 1 or 2, until a
beep sound is heard one time.
l
Programming to the key
Press the key
switch until a beep
sound is heard one time.
NOTE
If a beep sound is heard three times, the
operation is canceled.
Adjusting a programmed position
(Programming to a button on the seat
side)
1. While the vehicle is stopped, press the
programming button for the seat
position you want to call up (button 1
or 2).
2. A beep sound is heard when the seat
position adjustment is completed.
NOTE
l
If seat movement is not required, only the
beep sounds.
l
When the ignition is switched ON, the seat
position memory function does not operate
unless the selector lever is in the P position
(Automatic transaxle) or the parking brake
is applied (Manual transaxle).
l
When the ignition is switched OFF, the seat
position memory function is operable while
the selector lever is in a position other than
P position (Automatic transaxle) or the
parking brake is not applied (Manual
transaxle), however, if the ignition is
switched ON while the seat position
memory function is operating, the operation
is stopped.
l
The seat position adjustment is canceled in
the following cases:
l
Any of the seat adjustment switches is
operated.
l
The SET button is pressed.
l
Programming button 1 or 2 is pressed.
l
The key lock switch or unlock switch is
operated.
l
The vehicle starts moving.
(When programming to the key)
1. Unlock the doors by pressing a request
switch or the key switch.
Essential Safety Equipment
Seats
2-9
Mazda6_8EA2-EA-14K_Edition5 Page21
Friday, November 27 2015 4:55 PM
Form No.8EA2-EA-14K