Mazda 6 2016, Manual

Page: 198 / 610

Black plate (198,1)
Continue to press and hold the HomeLink
button while you
press and release
―
every two seconds (
“
cycle
”
) your hand-
held transmitter until the frequency signal
has successfully been accepted by
HomeLink. (The indicator light will flash
slowly and then rapidly.)
Proceed with
“
Programming
”
step 3 to
complete.
q
Operating the HomeLink System
Press the programmed HomeLink button
to operate a programmed device. The
code will continue being transmitted for a
maximum of 20 seconds.
q
Reprogramming the HomeLink
system
To program a device to HomeLink using a
HomeLink button previously trained,
follow these steps:
1. Press and hold the desired HomeLink
button. DO NOT release the button.
2. The indicator light will begin to flash
after 20 seconds. Without releasing the
HomeLink button, proceed with
“
Programming
”
- step 1.
q
Erasing Programmed HomeLink
Buttons
To erase the existing programming from
all three operating channels, press and
hold the two outside buttons (
, )
on the auto-dimming mirror until the
HomeLink indicator light begins to flash
after approximately 10 seconds.
Verify that the programming has been
erased when you resell the vehicle.
4-74
When Driving
Switches and Controls
Mazda6_8EA2-EA-14K_Edition5 Page198
Friday, November 27 2015 4:57 PM
Form No.8EA2-EA-14K