13
1031012 Rev.A 09/05
RE-ASSEMBLY
2. Re-install the following components:
a. Re-install the lower center console kick panels on both
driver and passenger sides. Re-secure the plastic fas-
tener on both. (FIGURE TT)
b. Re-install the steering column shroud by first securing
the ignition key light in place and then snapping the (2)
halves of the steering column shroud together. Re-in-
stall the (3) phillips screws on the bottom of the steering
column shroud. (FIGURE UU & VV)
c. Carefully pull the weather seal away along the door jamb
along the driver’s side lower dashboard. Re-mount the
driver’s side lower dashboard panel plugging in any con-
nectors that were removed earlier. Secure the weather
seal in place.
d. Re-install (1) phillips screw on the lower left side of the
driver’s side dashboard panel (FIGURE WW) and re-se-
cure the hood release handle.
14
FIGURE UU
FIGURE VV
FIGURE TT
FIGURE WW
SYSTEM POWER-UP
1. Verify that all connections are secure as per installation instructions.
2. Turn the ignition key to the RUN position.
3. Reconnect the negative battery terminal.
4. Turn the ignition key to the OFF position.
5. VERY IMPORTANT - USING THE IGNITION KEY, TURN THE IGNITION TO THE ON POSITION THEN
CRANK ENGINE UNTIL IT STARTS ONE TIME THEN SHUT THE VEHICLE OFF.
15
UNDERHOOD WARNING LABEL MOUNTING
16
1. Open the engine hood and find a suitable mounting location in the engine compartment that will
be in plain sight when the hood is open (on the radiator cowl).
2. Using an alcohol pad, clean the mounting surface thoroughly.
3. Remove the backing on the underhood sticker and mount in place.
4. Close hood.
