3
1031012 Rev.A 09/05
DIPOLE ANTENNA MOUNTING
1. Clean mounting spot with an alcohol pad prior to mounting. Mount
the dipole antenna to the windshield 210mm to the right of center on
the windshield, directly below the black windshield trim material. (FIG-
URE J)
2. Run the antenna wire above the headliner to the driver’s A-pillar,
using a fiber stick to secure under the headliner.
Note: Make sure the antenna wire is secure under the head
liner, if necessary remove the sun visor to secure.
3. Route the antenna wire down the A-pillar securing it to the existing
wiring using (3) supplied tie wraps. Do not secure it directly to the
sunroof drain tube or airbag. (FIGURE K)
4. Route the antenna wire behind the left side of the dashboard. The
antenna will be connected to the remote start control module later.
5. Re-install the driver’s side A-pillar panel and re-install the weather
seal along the A-pillar.
2
FIGURE J
FIGURE K
HOOD SAFETY SWITCH MOUNTING
1. Using (2) supplied 1/4” self drilling screws and (2) supplied lock washers, secure the hood safety switch to
the drivers side of the vehicle’s hood 95mm below the drain hole and 60mm from the side edge. (FIGURE
L & M)
2. Route the hood safety switch wiring down into the engine compartment along the inside of the hood hinge
and secure using (2) supplied tie wraps. (FIGURE L & N)
3. Route the hood safety switch wiring along the cowl panel, tucking under the cowl panel where possible, into
the engine compartment towards the hood release cable grommet. (FIGURE L & O)
4. Disengage hood latch cable and pull through radiator support bracket.
CAUTION: Failure to secure hood latch open with a tie wrap could allow the hood to become
locked without the hood release cable available.
a. Attach a tie wrap to the hood latch mechanism. (FIGURE P)
b. Disconnect the hood latch cable at latch.
c. Free the hood latch cable from (2) retaining clips. (FIGURE Q)
3
FIGURE N
FIGURE M
FIGURE P
FIGURE Q
FIGURE O
FIGURE L
