Fig. 4-3
2. Connect EC power harness to ground.
a) Locate 10mm ground bolt, upper left of wire
bundle in driver-side kick-plate area.
(Fig. 4-3)
b) Using 10mm socket, remove bolt.
c) Place ground ring from EC power harness, over
bolt and re-install bolt.
(Fig. 4-3)
d) Tighten bolt to 80-90 in. lbs.
3. Connect EC power harness to B+ wire tap.
Ground
Wire
Fig. 4-4
Black /
White-stripe
to
Orange /
Yellow-stripe
Solid Black
to
Orange /
Black-stripe
a) Insert male spade terminal of
solid black
harness wire into opening of wire tap on the
Orange / Black-stripe wire. (Fig. 4-4)
4. Connect EC power harness to +12V ignition.
a) Insert male spade terminal of
black / white-stripe
harness wire into opening of wire tap on
the
Orange / Yellow-stripe wire. (Fig. 4-4)
1. Bundle excess power harness and secure.
a) Bundle any excess power harness wires.
b) Secure bundled harness wires to factory wire
bundle with one (1) tie wrap.
(Fig. 5-1)
1. Reconnect negative battery cable.
2. Turn the ignition switch ON/ACC position.
3. With the vehicle in a fairly well-lit area, perform the
following
:
a) To make sure the auto-dimming feature is on,
verify that the green LED to the left of the
center switch is on. If it is not on, push the
switch to turn the green LED on.
b) Cover the forward looking photocell on the
back of mirror with a dark cloth or towel.
(Fig. 6-1)
NOTE
Fig. 5-1
!
Ensure male spade connectors are fully inserted into wire taps.
5
maining Harness Wires
Secure Re
Tie Wrap
6
Testing
Dark Cloth or Towel
Rearward
Photocell
Green LED
Compass
Display Window
Fig. 6-1
Page 6 of 8
Revision A
550-0336
