1. Plug 10-pin connector into back of EC mirror.
(Fig. 2-1)
2. Attach EC mirror.
a) Hold the mirror head and slide the mount
downwards as far as possible over the windshield
button, until fully seated.
b) Using a #T20 Torx, tighten the mirror mounting
bracket screw to 1.3 ft-lbs (17.8 kg-cm).
(Fig. 2-2)
Fig. 2-1
2
EC Mirror Installation
NOTE
!
1. Route EC harness from mirror to headliner.
a) Route power harness into groove of wire
cover and attach wire cover to mirror base.
(Fig. 3-1)
b) Slide upper portion of wire cover up to headliner
so the “forks” are held by the headliner.
(Fig. 3-1)
2. Route EC harness to driver-side A-pillar.
a) Route power harness between vehicle headliner
and roof to top of driver-side A-pillar area.
(Fig. 3-2)
3
Route EC Mirror Harness to Vehicle Power
Fig. 3-2
1.3 ft-lbs
Fig. 2-2
Fig. 3-1
Slide harness sleeve as close to mirror connector as possible.
Page 4 of 8
Revision A
550-0336
