Page: 6 of 10
11/5/2012
b) Disconnect the 12-pin connector.
(Fig. 4-2)
c) Plug the male connector side of the EC harness into the lower OE
connector and plug the female connector side of the EC harness
into the upper portion of the OE harness.
(Fig. 4-3)
1.
Secure remaining EC harness in driver-side A-pillar.
a) Place (1) piece of foam tape on top of the small OE connector and
the lower connector to prevent the EC harness from rattling.
(Fig.
5-1)
b) Fold the Wires of the jumper harness down so that the upper
connector rests on the foam tape. Bundle any remaining slack in
EC harness near the OE connectors in the bottom of the A-pillar.
Secure bundle and jumper harness to OE harness of smaller OE
connector with (1) wire tie, as shown.
(Fig. 5-2)
Secure EC Harness.
Fig. 4-2
Fig. 4-3
Lower
Connector
Fig. 5-1
Upper
Connector
Fig. 5-2
Wire Tie
Foam
Tape
See Locking Connectors Procedure on Page 2 for detailed instructions
and images of proper connector installation techniques.
!
NOTE
See Disconnecting Connectors Procedure on Page 2 for detailed in-
structions and images of proper connector removal techniques.
!
NOTE
See Wire Tie Procedure on Page 2 for detailed instructions and images
of proper wire tie installation techniques.
!
NOTE
Ensure EC harness does not interfere with airbag operation. Do not
secure wire ties to air bag or sunroof drain tube.
CAUTION
!
12-pin
Connector
