Page: 3 of 10
11/5/2012
1. Place kit components on a clean, padded surface, and inspect for
damage, defects, or missing components.
2. Record customer’s programmed Radio - AM/FM/SAT stations and
trip computer (if applicable).
3. Disconnect negative battery terminal.
a) Remove relay cover and then remove battery cover in order to gain
access to battery terminals.
b) Using 10mm socket, remove negative battery terminal.
(Fig. 1-1)
4. Remove driver-side door seal.
a) Pull back past top of A-pillar trim.
(Fig. 1-2)
5. Remove driver-side A-pillar trim.
a) Pull out the top portion of A-pillar trim towards passenger-side of
vehicle until A-pillar connector is extended approximately ½”.
b) Use needle nose pliers to grasp tab of A-pillar connector. Rotate tab
90 degrees and push down through slot in A-pillar trim.
(Fig. 1-3)
c) After A-pillar trim is detached from connector, pull A-pillar firmly to
detach lower clips.
Fig. 1-1
Preparation
10mm
Socket
C A U T I O N
!
Fig. 1-3
Fig. 1-2
Do not use excessive force. A-pillar could be damaged.
!
NOTE
INSTALLATION PRECAUTIONS / NOTES:
• If using fish wire, use caution to avoid damage to existing components.
• Do not place wire harness against objects with sharp edges that may cause electrical shorting.
• Verify that power harness path will not interfere with brake, clutch, emergency brake or air bag op
-
eration. Use wire ties to hold the wiring away from critical locations.
