MAZDA5
㧙
21
6. Pull the seam upward and route the antenna cable in the
seaming welt. (Does not need to be completely
removed.)
7. Reinstall the rubber seaming welt to its original position.
8. Cut the hole cover on the underside of the vehicle as
shown in the figure and cut out a section of the cover.
9. Route an antenna cable connector from the hole cover
on the vehicle underside.
10. Reinstall the hole cover.
x
It is critical that the antenna follows the route as
shown. Failure to follow this route will not provide the
slack required to open and close the liftgate.
x
Be careful not to tear the seaming welt when pulling it
up.
x
Do not remove trunk seam from the flange. The
antenna cable must not interfere with the flange seals.
CAUTION
㩷
Hole cover
Antenna cable connector
x
Install the antenna cable connector so that the part
going through the hole cover is pointed towards the
rear of the vehicle.
x
Make sure the hole cover is reinstalled securely to
prevent water from penetrating the vehicle cabin.
CAUTION
mm {in}
Cut
3 {0.11}
Hole cover
3 {0.11}
15 {0.59}
20 {0.78}
Antenna cable
Seaming welt
Vehicle front
