![Maytag MGDZ600TK - Front Load Gas Dryer Install Manual Download Page 14](http://html1.mh-extra.com/html/maytag/mgdz600tk-front-load-gas-dryer/mgdz600tk-front-load-gas-dryer_install-manual_1748302014.webp)
14
3.
Insert strike on the opposite side.
B
A
A. Plug strip (cannot be seen from this angle)
B. Door strike
Reinstall the door
1.
Reattach door to dryer front panel with the 4 screws.
A
B
A. Dryer front panel
B. Door assembly
2.
Check for fingerprints on the glass. Clean glass if necessary.
3.
Close door and check that it latches securely.
TROUBLESHOOTING
First try the solutions suggested here and possi
b
ly avoid the cost of a service call...
Dryer Operation
Dryer will not run
■
Has a household fuse
b
lown, or has a circuit
b
reaker
tripped?
There may be 2 household fuses or circuit breakers for the dryer.
Check that both fuses are intact and tight, or that both circuit
breakers have not tripped. Replace the fuse or reset the circuit
breaker. If the problem continues, call an electrician.
■
Is the correct power supply availa
b
le?
Electric dryers require 240-volt power supply. Check with a
qualified electrician.
■
Was a regular fuse used?
Use a time-delay fuse.
No heat
■
Has a household fuse
b
lown, or has a circuit
b
reaker
tripped?
The drum may be turning, but you may not have heat. Electric
dryers use 2 household fuses or circuit breakers. Replace the
fuse or reset the circuit breaker. If the problem continues, call
an electrician.
Dryer displaying code message
■
“PF” (power failure), check the following:
Was the drying cycle interrupted by a power failure?
Press and hold START/PAUSE to restart the dryer.
Try the following:
Check to see if a household fuse has blown or circuit breaker
has tripped. Electric dryers use two household fuses or
breakers. Replace the fuse or reset the circuit breaker.
Confirm the power cord is properly installed.
Select a Timed Dry heated cycle, and restart the dryer.
If the message persists, consult a qualified electrician.
■
“F” Varia
b
le (F1E1, F2E2, F3E1, F3E2, F7E1, F3E6, F3E7)
service codes:
Call for service.
■
For all models without a display window:
If the “WET” indicator light is flashing and all other display/
indicator lights on the control panel are off:
Call for service.