Installation
10
Oven Assembly
CONVEYOR BELT TENSIONER
NOTE: Each tensioner installs between the idle
end of the conveyor (the side opposite the
drive) and the lower end plug.
1. Compress the tensioner assembly spring by
hand.
2. Engage the tensioner pin with the hole in the
lower end plug.
3. Lift to engage the pin on the opposite side with
the conveyor.
Figure 15
CRUMB PANS
1. Install crumb pans under each end of the con-
veyor.
Figure 16
OPTIONAL REMOTE COMPUTER CONTROL
1. Drill the mounting holes for the cooking com-
puter support base.
2. Mount the support base and cable support
bracket to the wall.
3. Stack the cooking computer(s) on the support
base. Connect the cables at the rear of the
controller.
4. Secure the cables to the cable clamp support
bracket and to the rear of the oven using cable
clamps and screws.
NOTE: DO NOT overtighten the cable
clamps. Damage to the wires may oc-
cure causing the computer to fail.
Cable Clamp
Support Bracket
Cooking Computer
Support Base
Cooking Computer
Figure 17
