11
ENG
Changing the Batteries in the Remote Control
1. Remove the cover on the battery compartment at back of the remote control. To do this put your thumb on
the ribbed and slightly indented markings on the top of the battery compartment cover and push this back
whilst pushing gently down with your thumb.
2. Change the batteries. The remote control needs 2 type AAA Micro 1.5V batteries.
3. Replace the cover to the battery compartment.
CAUTION:
Before you perform any care, cleaning, maintenance, repair or similar work on your training device, it
must be completely disconnected from the mains. This is only the case if the plug is removed from the
electrical power supply socket and the mains cable is disconnected from the device. When doing this
always remove the plug from the socket first and then disconnect the mains cable from the device. The
mains cable may only be reconnected to the device and then plugged into the electrical socket when all
work is fully completed, and the device is restored to perfectly functioning condition.
Cleaning
Clean your device after each training session using a damp cloth and soap. Never use solvents for this purpose.
Regular cleaning contributes significantly to the preservation and life service of your training device.
Damage caused by body perspiration or other liquids will not under any circumstances be covered by the war-
ranty. During training make sure that no liquids get into contact with the device or get into the computer.
Maintenance
Checking the Fixing Materials
Make regular checks to ensure that fixing materials such as screws, nuts etc are tightened firmly. If not, tighten
them wherever necessary.
This training device was exclusively designed for use indoor dry and temperate areas.
Use or storage in damp or wet areas, such as sauna, swimming pool, etc. and in outdoor areas,
like balcony, terrace, garden, garage, etc. is not permitted.
In these locations the prevailing high humidity and low temperatures may lead to defects in the electronics, cor-
rosion and rust. No warranty claims for damages of this kind will be accepted under the warranty.
Please choose a dry, well-tempered and completely flat location for training and storage of this device. For train
-
ing, locate the device in an area where the walls and furniture are at least 1 meter away from the device.
For your own safety and comfort, make sure that the training area is adequately ventilated during exercise, to
allow for optimal oxygenation.
Before using your training device after a long period of non-use, make sure that all fixings are secured tightly. If
you have stored the product for a long time in a cold storage location or otherwise have stored it in a non-tem-
perate place, leave the device for at least one hour at room temperature before switching it on again.
Technical Information
Cleaning & Maintenance
Location and Storage
Training
Summary of Contents for Lifeplate 2.0
Page 1: ...2 0 ENG User Guide...
