Ultra ATA/100 PCI Adapter Card
B
B
A
A
C K
C K
F O R
F O R
W
W
A R D
A R D
Adapter Card Installation
(cont.)
5. If applicable, attach the LED cable connector on
your system case to the LED connector on the
Ultra ATA/100 PCI Adapter Card (Figure 2).
Hard Drive Installation
NOTE: If you're installing the Ultra ATA/100 PCI
Adapter Card into a system with an existing
Windows NT operating system, do not connect any
hard drives to the Ultra ATA/100 PCI Adapter
Card before installing the driver software.
Some OEM systems require a BIOS change for
SCSI add-in cards.
Drives attached to the Ultra ATA/100 PCI Adapter
Card cannot boot Windows NT without driver
support. See Software Installation, Option C, Step
1C for details.
1. Configure the jumpers of the hard drive(s) you're
preparing to install with the Ultra ATA/100 PCI
Adapter Card with the appropriate master/slave
settings.
You may need to refer to your hard drive's
manual for more information.
NOTE: Do not apply any jumper that is meant
to reduce the capacity of the hard drive.
6. Fasten the adapter card bracket to the system case.
Figure 2
Adapter Card Connections
LED
connector
32-pin PCI connector
IDE 2
(secondary)
IDE 1
(primary)
pin 1
