Maxtec SHOCKBLAZE, Use And Instruction Book, Page: 7 / 42

ENGLISH
45
stem in the right position (with
20 Nm).
If you have a Ahead set han-
dlebar the height cannot be
adjusted. In this case you have
to operate on the two screws
that lock the handlebar (stee-
ring) A1 and A2 (fig. 5). You
can set the steering flowability
by adjusting the B screw.
Finally lock the A1 and A2
screws again (with 12-14 Nm).
WARNING/IMPORTANT:
The handlebar has never to be
raised over the stem limit mark
that indicate the minimum
insert level.
Check if the handlebar is well
fixed by turning it after you
blocked the front wheel bet-
ween your legs (fig. 7).
CHECK
if the front brake is applied by
the right or left lever and test
its efficiency in order to avoid
any tumble due to a wrong
use.
CHECK
the complete pedals locking
(see next chapter).
CHECK
the light device that should be always efficient.
Fig. 5
Fig. 6
Fig. 7
B
A1
A2
LIBRETTO_Layout 1 25/10/10 18:44 Pagina 45