Maxtec SHOCKBLAZE, Use And Instruction Book, Page: 19 / 42

The quick release has to be
correctly adjusted and fasten-
ed as described here below.
To take the wheel out, you
have to open the quick release
of the side pull brakes or
remove the cantilver of V-
brake arc; pull the hubs relea-
se lever until you reach posi-
tion OPEN (Fig. 21) and loosen
the fixing nut reverse. Now the
wheel can be removed from
the dropouts.
To reassemble the wheel you
have to position its axle betwe-
en the dropouts, the lever has
to be in the middle between
OPEN and CLOSE position,
bolt the nut reverse until you
close it with your fingers (Fig.
22); using your hand palm
move the lever until you reach
position CLOSE and you feel a
little resistance (Fig. 23).
When you have finished, check if
the lever is parallel to the wheel,
it has never to jut out sideways.
To check if the wheel is well
fastened, you have to raise your
bicycle and strike the wheel with
strength (Fig. 24) in order to be
sure that it does not come off,
move sideways or slacken.
If your bicycle is equipped with
nut hubs you have to check if
the are well closed according
ENGLISH
57
Fig. 21
Fig. 22
Fig. 23
Fig. 8
OPEN
CLOSED
LIBRETTO_Layout 1 25/10/10 18:44 Pagina 57