27
Chapter 6 Operation Guide
4-Start Steps
WARNING:
◎ Make sure that all the electrical connections (including cooling water
connections) are connected prior to use. All the connectors must be held
steady with screws if possible.
◎ NEVER look directly into the output fiber and make sure that you wear
the laser safety eyewear while operating the product.Make sure all power
is removed from the laser when wiring.
Start steps are as follows:
1、Start the water-cooling machine;
2、Remove the end cap of the collimator;
3、Make sure that the end surface of the collimator is clean and not
covered with impurities;
4、Make sure that the emergency stop switch is turned on;
5、Place the Power Main Switch of the front panel on position "ON";
6、Place the Key Switch of the front panel on position "ON";
7、Press the START button on the front panel.
8、The air-condition is controlled automatically by the system and it will
begin cooling in 3 minutes after being started, or else it may malfunction.
5-Mode Description
The working modes of the laser are as follows:
1、CW Mode：The light emitted is continuous and this mode is used for
cutting.
