10
Chapter 2 General Safety Information
1、Never look directly into the laser output port when the power is turned
on.
2、Avoid positioning the laser and all optical output components at eye
level.
3、Equip with laser beam casing.
4、Remove the end-cover before switch ON the laser. Or else the output
head will be damaged irreversibly.
5、Ensure that all personal protective equipment is suitable for the output
power and wavelength range of the laser.
6、Use the laser in a room with access controlled by door interlocks. Post
warning signs. Limit the safety areas to operate the laser.
7、Please do not operate the laser in darkened environments.
8、Do not turn on the laser without an optical coupling fiber or an optical
output connector.
9、Carry out commissioning, calibration and focusing at low output power
and then increase the output power gradually when the calibrating and
focusing work is done.
10、Do not install or detach cutting heads or collimators when the laser is
active
11、Make sure that the laser is shut down and the power is off before you
install or detach cutting heads or collimators.
12、If the equipment is operated in a manner not specified in this
document, the protection devices and performance of the equipment may
be impaired and the warranty will be voided.
CAUTION:
◎ The output of the laser is delivered through a lens with an anti-reflection
