MAXPHOTONICS CO.,LTD
WWW.MAXPHOTONICS.COM
15
2.
4. Operation
4.1 Preparing for use
4.1.1 Checking the fiber laser power, marking system power and computer connected
finished
1.1.2 Checking the signal of marking system and fiber laser power.
MAXPHOTONICS CO.,LTD certifies that this instrument has been thoroughly tested
and inspected, and found to meet published specifications prior to shipping.
NOTE: Upon Receiving your device check the packaging and parts for any possible
damage that may have occurred in transit. If damage is apparent please contact
MAXPHOTONICS CO.,LTD immediately.
4.2 Operation Steps
4.2.1 Operation Steps
Turn on the fiber laser power, then the marking system power(make sure that the fiber
laser power on and the fan running within the 180s warm-up time of the marking
system ),otherwise, should return-on according the order and turn on the computer
power at the end.
4.2.2 Operation steps of checking laser marking system after turning on
When start to test the fiber laser after start-up finished, please set up the power to
0W,then make a picture, marking continually and add the power from 0W to 20W.
And also to test by using a camera paper, and notice that the laser must be getting
stronger( the step should be taken when starting the machine each time, please turn
off the machine to check when the laser does not become stronger or there isn’t any
laser. After the work in order, marking can be started following the normal procedure.
4.3 Warning
4.3.1 The highest frequency should be70KHz
4.3.2 Please be careful when you adjust the rate of frequency when marking, or it will
influence the marking results.
4.3.3 It’s workable for MAXPHOTONICS fiber laser to turn off the laser power directly
