Knuckle Surface (KS)
1.)
Secure Wall Mount Bracket to Quadromax by tightening (2) 5/16-18 Internal HEX Head bolts with
split washers and gasket.
2.)
Orient Wall Mount Box and TOP position must be pointed up.
3.)
Secure Wall Mount Box to a Sturdy Mounting Surface.
4.)
Apply silicone sealant and seal the gap between wall and wall mount box Gasket and / Or Junction
box if needed.
5.)
Wire the fixture using UL listed wire connectors
6.)
Placed wired fixture over the Wall Mount Box and tighten the (2) 3/8-16 Internal HEX Head bolts
with split washers.
7.)
Check and make sure Gasket was compressed.
8.)
Adjust wall mount to desired angle by Loosening center bolt and adjusting accordingly.
9.)
Tighten ½” NPS plug and apply silicone sealant to all unused conduit entry points.
QuadroMAX LED Fixture
