background image

WAL-QP8-WP60PM-GRC50

 

Larson Electronics, LLC

 

  Phone: (800) 369-6671 

 Fax: (903) 498-3364 

  www.larsonelectronics.com 

1

 of 

1

 

60 Watt Base Stand Work Area LED Light Tower - Quadpod Mount 

Instruction Manual

Thank you for your purchase of the Larson Electronics 

WAL-QP8-WP60PM-GRC50

. Please follow the steps 

below in order to operate and maintain this product. 

IMPORTANT 

READ CAREFULLY BEFORE OPERATING  THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE 
REFERENCE. 

WAL-QP8-WP60PM-GRC50 

 MUST BE OPERATED IN ACCORDANCE WITH NATIONAL ELECTRICAL 

CODE AND ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY. 

WARNING: 

OPERATE THIS FIXTURE ONLY AT THE VOLTAGE OF YOUR SPECIFIC SUPPLY CIRCUIT. FAILURE 

TO DO SO WILL RESULT IN DAMAGE TO THE FIXTURE. 

WARNING: 

SUBSTITUTE COMPONENTS MAY IMPAIR SAFETY. 

OPERATING 

Before operation, confirm that the power source will provide the correct voltage indicated on the product 
nameplate. Ensure the receptacle will accept the cord cap attached to the light.  

Place the light in the desired location and run its power cord to a power source. 

The light head can be adjusted by loosening the screws on each side, positioning the light head and tightening 
the screws to hold the light in place. 

This light is “instant-on” once plugged in to a live circuit. 

AVOID DIRECT EYE EXPOSURE

 

Do not look at the face of or directly into the light when plugging in or when 

illuminated.

 

USE AND CARE

Unauthorized modification may impair the function and/or safety of the extension cord and could affect the life of the 
equipment. Always check damaged or worn out parts before using. When not in use, store in a secure place out of the 
reach of children. Inspect for good working condition prior to storage and before re-use.

 

 

TROUBLESHOOTING 

Refer to the guide below or contact the manufacturer if the fixture does not function properly. 

Is the correct line voltage being supplied to the fixture?

Is the fixture properly grounded?

Make sure installed power switch is functioning properly (if applicable).

60 Watt Portable LED Work Area Light

Summary of Contents for WAL-QP8-WP60PM-GRC50






Reviews: