11. Turn down the lid so that the two pins on the rear edge of
the lid are guided through the slots in the mixing container
into the motor unit.
12. Press down the mixing container lid until it locks in place.
The device has a safety switch. This is located
inside the motor unit and is activated by a pin on
the mixing container lid. The device can only be
switched on using the
On/Off switch if the mixing container lid is placed
on correctly and the pin activates the safety switch!
Use
CAUTION!
❐
Only connect the device to a socket that is properly installed, is easily accessible and
corresponds to the technical data of the device (see the "Technical Data" chapter).
❐
The device has a safety switch. It is located inside the motor unit and is activated by a
pin on the mixing container lid. The device can only be switched on using the On/Off
switch if the mixing container lid is placed on correctly and the pin activates the safety
switch. If the pin on the mixing container lid is damaged, do not attempt to activate the
safety switch or bypass/repair it using your own hands. In the event of a defect, contact
the customer service department (see the "Customer Service" chapter). Stop using the
device until it has been repaired.
❐
Make sure that the On/Off switch is in the
OFF
position before you connect the device
to the mains power.
❐
Do not over
fi
ll the mixing container! Excessively large quantities of ingredients may cause
damage to the device. Larger quantities should be spread between two or more kneading
operations. The
fi
ll level per operation should not be more than approx. 450 g.
❐
Do not operate the device for more than 15 minutes without interruption! Operating
the device continuously for too long may cause damage to the device. Switch the device
off after 15 minutes and let it cool down for a few minutes before you switch it back on
again.
❐
If dough gets stuck during kneading or the kneading spiral does not rotate evenly, never
attempt to reach through the slot-shaped openings in the mixing container lid using your
fi
ngers or an object to try to clear the reason for the blockage. Always pull the plug out
and then open the mixing container lid to
fi
nd out what the reason is for the blockage
(e. g. dough too dry).
❐
Make sure that the openings of the respective pasta attachment do not become blocked
during the extrusion of the pasta dough! In this case, use the On/Off switch to switch the
device to the
OFF
position and then remove the blockage. Never insert objects into the
openings of the pasta attachments while the device is switched on.
