MAXIMUM
®
Air-powered
Hammer/Chisel
13
12
model no. 058-9365-2 | contact us 1-888-670-6682
WARNING!
Potential hazard that could result in serious injury or
loss of life.
• Use of high-pressure air or unclean air may cause
excessive noise and rapid wear, which will shorten
the life of the tool.
• Keep hands and other parts of the body away from the
work areas when connecting the air supply. Failure to
comply could lead to serious injury or loss of life.
• Do not use the tool if it is not in proper working order.
• Do not use oxygen or any other combustible or bottled gas to
power this
tool.
• Do not use this tool in the presence of any flammable liquids
or gases.
• Keep hose away from heat, oil and sharp edges. Check hose for
wear and
tear.
• Ensure the air supply is clean and has a regulated pressure o
f 90 psi(6.3 bar)
• Ensure that all connections are secure. Failure to comply cou
ld lead to
serious injury or loss of life.
• It is recommended that an automatic in-line filter-regulator-l
ubricator be
used and be located as close to the tool as possible.
• If a filter-regulator-lubricator is not installed, place up to six drops of oil
directly into the air inlet plug before each use.
• If a filter-regulator-lubricator is installed, keep the air fil
ter clean. A dirty
filter will reduce the air pressure to the tool, which will c
ause a reduction
in power, efficiency, and general performance.
AIR TOOLS
Read this instruction manual thoroughly and have tool :
operators read thoroughly before using the tool.
• Read all safety guidelines (see section “Safety guidelines”)
at the
beginning of this manual.
• Always inspect the air tool prior to each use to
– Ensure proper use of power source.
– Determine whether the tool is in proper working order.
• Drain the compressor tank daily. Water in the air-supply line
will damage
the tool.
• Clean air inlet and filter weekly.
• Line pressure should be increased to compensate for unusually
long air
hoses. The hose diameter should be 3/8" (9.5 mm) ID. The fitt
ings must
have the same inside dimensions.
• Ensure that the trigger is not pressed before connecting the
tool to the air
supply.
• Use only the chisels and quick-retention spring specifically d
esigned for
this Air-powered Hammer/Chisel. Failure to comply may result in
moderate injury or damage to equipment.
• Verify that all connections in the air-supply system
are sealed in order to prevent air from leaking.
Failure to comply may result in moderate injury or
damage to equipment.
CAUTION!
Potential hazard that may result in moderate injury or
damage to equipment.
Description
No.
1
2
3
4
No.
5
6
7
Filter
Cut-off valve
Air compressor
Air system
• Always use clean, dry, regulated, compressed air at a pressur
e of
60 to 100 PSI(4 to 7 bar)and specific flow rate (see section
“Technical Specifications”).
1
2
3
5
4
6
7
Air hose
Lubricator
Regulator 0 to 123 psi
(0 to 8.5 bar)
Description
Hammer/chisel
TM
