Fig. 24
1
2
OPERATION
63
62
model no. 055-9033-8 | contact us 1-800-689-9928
model no. 055-9033-8 | contact us 1-888-670-6682
OPERATION
WARNING!
Always use push sticks, and/or other cutting aids
such as push blocks, or featherboards (these aids are
not supplied) when making non-through cuts to avoid the
risk of serious injury.
WARNING!
Once all non-through cuts are completed, unplug
saw and reinstall riving knife in uppermost position.
Install anti-kickback pawls and blade guard.
WARNING!
Read the appropriate section which describes the type
of cut in addition to this section on non-through cuts.
For example, if your non-through cut is a straight
cross cut, read and understand the section on straight
cross cuts before proceeding.
WARNING!
Make sure the blade guard is reinstalled immediately
after making any adjustment which requires it to be
removed. Failure to heed this instruction could result
in serious personal injury.
•
•
•
•
•
•
•
•
•
Lock release lever.
Remove blade guard and anti-kickback pawls.
Place the riving knife in the middle position.
Set blade to correct depth for workpiece.
Depending on shape and size of wood, use either rip fence or mitre gauge.
Plug saw into power source and turn saw on.
Let blade build up to full speed before moving workpiece into blade.
Always use push blocks, push sticks, and/or featherboard when making non-through
cuts to reduce the risk of serious injury.
When cut is made, turn saw off. Wait for blade to come to a complete stop before
removing workpiece.
•
•
•
Unplug the saw.
Loosen and not remove the thumbscrew (1),
then open the small baffle (2).
Clean out the excess dust, then push the small
baffle in place and tighten the thumbscrew.
ADJUSTMENTS
The table saw has been adjusted at the factory for making very accurate cuts. However,
some components might have been jarred out of alignment during shipping. Also, over a
period of time, readjustment will probably become necessary due to wear.
Carefully check alignment with a framing square before beginning adjustments to
confirm whether they are necessary. Use test cuts after completing adjustments to avoid
damaging workpiece.
DUST COLLECTION (Fig. 24)
This table saw is equipped with a dust shroud
and dust collection port. For best results,
connect a vacuum to the port at the rear of the
saw. After extended use, the saw’s dust
collection system may become clogged.
To clear the dust collection system:
WARNING!
Before performing any adjustment, make sure tool
is unplugged from power supply and switch is in
off position. Failure to do so could result in serious
personal injury.
WARNING!
When making a non-through cut, blade is covered by workpiece during most of
cut. Be alert to exposed blade at start and finish of every cut to avoid the risk of
personal injury.
WARNING!
Never feed wood with hands when making any non-through cuts such as
rabbets. To avoid personal injury, always use push sticks and or other cutting aid (such
as push blocks, featherboards) so hands do not come within 6" (15 cm) of blade.
A push stick is included with your saw. Additional push sticks and other cutting aids can
be purchased separately at any authorized dealer.
Summary of Contents for 055-9033-8
Page 1: ......
