Fig. 7a
ASSEMBLY
39
38
model no. 055-9033-8 | contact us 1-800-689-9928
model no. 055-9033-8 | contact us 1-888-670-6682
ASSEMBLY
•
•
•
Using one opened-ended blade wrench (1),
place the flat open end on the flats on the
inner blade flange (2).
Using the other opened-ended blade wrench
(3), place the flat open end on the flats on
the arbour nut (4). Holding both wrenches
firmly, pull the opened-ended blade wrench
on the arbour nut (4) forward to the front of
the machine.
Remove arbour nut (4), outer blade flange
(5) and saw blade (6).
•
•
•
•
Remove the blade:
•
•
Place one new blade on arbour (7). Make sure
saw blade teeth point down at the front side
of saw table. Place outer flange (5) and nut
(4) on arbour and use blade wrenches to
tighten nut securely.
DO NOT
over tighten.
Lower the saw blade to lowest position and
replace table insert.
Install the blade:
Unplug the saw.
Turn height adjustment knob clockwise to
raise blade to maximum height.
Remove the table insert.
Remove the blade wrenches from storage
area.
REMOVING AND INSTALLING THE BLADE
(Fig. 7a-7b)
Fig. 7b
2
6
7
5
6
4
3
1
WARNING:
Only use a 10" (25.4 cm) diameter blade. To avoid
injury from an accidental start, make sure the switch
is in the OFF position and the plug is not connected
to the power source outlet.
CAUTION:
To work properly, the saw blade teeth must point
down toward the front of the saw. Failure to heed
this instruction could cause damage to the saw
blade, the saw or the workpiece.
WARNING!
Make sure that the saw blade is installed to rotate
in the proper direction. Do not use grinding wheels,
wire brushes, or abrasive wheels on a table saw.
Improper saw blade installation or use of accessories
not recommended may cause serious injury.
WARNING!
The large, flat surface of the outer flange faces the
the saw blade and the saw blade (6) is firmly seated
against the inner flange (2).
WARNING!
Be extremely careful when loosening arbour nut.
Keep firm grasp on both wrenches. Do not allow
hands to slip and contact blade.
7
4
5
WARNING!
If the inner flange has been removed, reinstall
it before placing the saw blade on arbour. Failure
to do so could cause an accident.
Summary of Contents for 055-9033-8
Page 1: ......
