Fig. 8b
•
•
•
•
•
•
•
Unplug the saw.
Set the blade angle to 0°.
Raise the saw blade to maximum height by
turning height adjustment knob clockwise.
Lock the blade by turning bevel locking lever
clockwise.
Place the riving knife in the highest position.
Pull out and hold knob (1) and push
anti-kickback pawls up. Remove it from the
anti-kickback pawls storage located on inside
of the left side rear of saw. (Fig. 8a)
Pull out and hold knob (1). Align slot in
anti-kickback pawls (2) over the slot
indicated of riving knife (3). Place the spring
pin (4) on the anti-kickback pawls (2) into
the slot indicated on the riving knife (3).
Press anti-kickback pawls (2) down until it
snaps into place and release knob (1) to
insert the pin (5) into hole (6) indicated on
the riving knife (3).
Anti-kickback pawls should only be installed
for through cuts.
ANTI-KICKBACK PAWLS AND BLADE
GUARD INSTALLATION (Fig. 8a-8b)
BLADE GUARD INSTALLATION
(Fig. 9a-9c)
ASSEMBLY
41
40
model no. 055-9033-8 | contact us 1-800-689-9928
model no. 055-9033-8 | contact us 1-888-670-6682
ASSEMBLY
Fig. 8a
•
•
Unplug the saw.
Hold the knobs (1) (one on either side of the
blade guard) and push the knobs forward to
the front of the blade guard and up until the
pin comes out from the slot in the mounting
bracket (blade guard storage) underneath
the anti-kickback pawls storage, then remove
the blade guard from the mounting bracket.
(Fig. 9a)
•
Hold and push knobs (1) forward to the front
of the the blade guard. Place the pins (2, 3)
on the blade guard (4) into the slots indicated
on the riving knife (5). (Fig. 9b)
4
Fig. 9a
Fig. 9b
1
2
WARNING!
Use extra caution when cutting wood products
having slippery surface as the anti-kickback pawls
may not always be effective.
CAUTION:
Pull up on anti-kickback pawl assembly to make
sure it is secured to riving knife.
1
1
WARNING!
KEEP GUARDS IN PLACE and in good working
order for all through cut operations. Reinstall the
blade guard immediately after finishing any
non-through cut operations which require removal
of the blade guard. Failure to heed this instruction
could result in serious personal injury.
WARNING!
Make sure the anti-kickback pawls are
reinstalled immediately after finishing any
non-through cut operations which require
their removal.
WARNING!
Replace dull or damaged anti-kickback
pawls. Dull or damaged anti-kickback pawls
may not stop a kickback, increasing the risk of
serious personal injury.
2
6
3
1
4
5
1
1
5
2
4
1
3
1
Summary of Contents for 055-9033-8
Page 1: ......
