Connecting is a two step process. First, on the receiver, press and hold the channel assignment switch until the green status LED
begins rapidly flashing, then release; this will clear any existing assignment for that particular channel. Hold down the
connection switch on the transmitter. If it is not currently connected to a receiver, it will begin flashing rapidly until successfully
connecting. Detailed instructions are given below.
EKd͗
If there are no existing connections, the
receiver’s
status LED will blink rapidly
while it is finding a clean operating frequency (this can last a few seconds)
After initialization, the system status LED will flash on/off once every 2 seconds
Set
ĞĂĐŚ
channel to the desired OPEN/CLOSE direction function using the MODE dip switch
/ĨĂ/WƐǁŝƚĐŚŝƐŝŶƚŚĞKWEƉŽƐŝƚŝŽŶ͕ƚŚĞŶƚŚĂƚĐŚĂŶŶĞůǁŝůůƚƌŝŐŐĞƌƚŚĞKWEZĞůĂLJŽŶ
ƌĞĐĞŝǀĞƌ͘KƚŚĞƌǁŝƐĞ͕ŝƚǁŝůůƚƌŝŐŐĞƌƚŚĞ>K^ZĞůĂLJ͘
Install 2 AA Lithium batteries in the
WEL-200T (transmitter)
The green LED on the transmitter will quickly flash 2x every two seconds
Install a properly terminated edge to the
transmitter
(8.2k or 10k termination)
On the
receiver
, hold down the desired channel assignment switch until all four channel
LEDs
activate and the system status LED begins flashing rapidly, then release
the switch.
On the
transmitter
, hold down the connection switch (next to the terminal block)
The LED on the
transmitter
will begin flashing rapidly after ~4 seconds
Upon successful connection, the LED will flash once every two seconds
If
the
transmitter
fails to connect, it will return to its initial state, with the
LED flashing twice every two seconds. If this occurs, repeat step
Ɛ
ĂďŽǀĞ͘
1
2
3
4
5
Testing
Without activating the edge, observe the channel status LED, it should be OFF.
When the edge is activated, the
receiver
channel status LED will turn on and
the
corresponding OPEN/CLOSE direction output will activate. The
transmitter
status LED will blink once every
second
when the edge is activated.
If the channel does not exhibit this behavior, double check the edge
wiring/termination and transmitter batteries.
CONNECTING RECEIVER (WEL-200R) TO TRANSMITTER (WEL-200T)
STEPS
TESTING
2
5,3TANDARD-!802/02/&02/-ATRIX))))NSTALL6ERSIONB
Testing
FACTORY RESET
WŽǁĞƌĚŽǁŶƌĞĐĞŝǀĞƌ͘,ŽůĚĐŚĂŶŶĞůƐϭĂŶĚϰĚŽǁŶƐŝŵƵůƚĂŶĞŽƵƐůLJǁŚŝůĞ
ƉŽǁĞƌŝŶŐƌĞĐĞŝǀĞƌďĂĐŬƵƉ͘
Summary of Contents for MATRIX III MAX 1500 PRO
Page 43: ...PQVGU ...
