MAXDATA VISION 350M, User Manual

Page: 85 / 373

Appendix C AGENCY REGULATORY NOTICES
C-3
n
EN50082 (IEC801-2, IEC801-3, IEC801-4) Electro-magnetic
Immunity
n
EN60950 (IEC950) Product Safety
Canadian Notice
This digital apparatus does not exceed the Class B limits for radio
noise emissions from digital apparatus as set out in the radio
interference regulations of the Canadian Department of
Communications.
Le present appareil numerique nemet pas de bruits radioelectriques
depassant les limites applicables aux appareils numeriques de
Classe B prescrites dans le reglement sur le brouillage
radioelectrique edicte par le Ministere des Communications du
Canada.
Power Cord Requirement
The power cord supplied with the notebook AC adapter should match
the plug and voltage requirements for your local area. Regulatory
approval for the AC adapter has been obtained using the power cord
for the local area. However, if you travel to a different area and need to
connect to a different outlet or voltage, you should use one of the
power cords listed below. To purchase a power cord (including one
for a country not listed below) or a replacement ac adapter, contact
your local dealer.
U.S. and Canada
n
The cord set must be UL-Listed and CSA-Certified.
n
The minimum specifications for the flexible cord are (1) No. 18
AWG, (2) Type SJ, and (3) 3-conductor.
n
The cord set must have a rated current capacity of at least 10 A.
n
The attachment plug must be an earth-grounding type with a
NEMA 5-15P (15A, 125V) or NEMA 6-15P (15 A, 250V)
configuration.
Japan
n
All components of the cord set (cord, connector, and plug) must
bear a `T` mark and registration number in accordance with the
Japanese Dentori Law.
n
The minimum specification for the flexible cord are: (1) 0.75
mm
2 conductors, (2) Type VCT or VCTF, and (3) 3-conductor.
n
The cord set must have minimum rated current capacity of 7 A.
n
The attachment plug must be a two-pole, grounded type with a
Japanese Industrial Standard C8303 (15 A, 125 VAC)
configuration.
Other Countries
n
The cord set fittings must bear the certification mark of the
agency responsible for evaluation in a specific country. Accept-
able agencies are:
BSI (UK)
OVE (Australia)