MAXDATA PLATINUM 110, System Manual

Page: 17 / 31

16 Server Description 17 MAXDATA PLATINUM 220 Server
Network Interface Controller (NIC)
The server board S875WP1-E supports two Network Interface Controllers (NICs), one that runs at
10/100 Mb and is Based on the Intel
®
82562ET NIC and the other that runs at one gigabit and is
Based on the Intel
®
82547EI NIC. When looking at the rear of the chassis, the gigabit NIC is at the
left (closest to the video port) and the 10/100 Mb NIC is at the right. You can disable either or both
NICs through BIOS Setup.
The 82562ET is controlled by the ICH5-R and supports the following features:
• Integrated IEEE 802.3 10Base-T and 100Base-TX compatible PHY.
• IEEE 802.3u auto-negotiation support.
• Full duplex support at both 10 Mbps and 100 Mbps operation.
• Low power +3.3V device with reduced power in unplugged mode and automatic detection
of unplugged mode.
• 3-port LED support.
The 82547EI is controlled by the CSA interface off of the MCH. It supports the following features:
• Basic 10/100/1000 Ethernet LAN connectivity.
• Integrated Gigabit Ethernet Media Access Control (MAC) and physical layer (PHY).
• IEEE 802.3 10Base-T/100Base-TX/1000Base-T compliant physical layer interface.
• IEEE 802.3ab auto-negotiation support.
• Low power (less than 350mW in active transmit mode).
• Reduced power in “unplugged mode” (less than 50mW).
• Automatic detection of “unplugged mode”.
• Communication Streaming Architecture (CSA) port provides higher throughput and lower
latencies resulting in up to 30% higher bus throughput (up to wirespeed).
• Full device driver compatibility.
• Programmable transit threshold.
• Configuration EEPROM that contains the MAC address.
• Teaming and Fail over support.
NIC Connector and Status LEDs
Two LEDs are built into each RJ-45 LAN connector. For the 82562ET NIC, the yellow LED indicates a
link to the LAN and the green LED indicates the connection speed. Table 5 describes the LED states
when the board is powered up and the 82562ET 10/100 Ethernet LAN subsystem is operating.
Table 5. 10/100 Ethernet LAN Connector LEDs
LED Color LED State Indicates
Green
(left LED) Off 10 MBit/sec data rate is selected.
On 100 MBit/sec data rate is selected.
Yellow
(right LED) Off LAN link is not established.
On (steady state) LAN link is established.
On (brighter and
pulsing) The computer is communicating with another computer
on the LAN.
Table 6 describes the LED states when the board is powered up and the 82547EI 10/100/1000 Gigabit
Ethernet LAN subsystem is operating.