6–2
MAINTENANCE
www.maxcessintl.com
MAGPOWR DTR-65
MI 850A349 1 D
Fuse replacement
continued
4.
After replacement of any bad fuses, carefully slide the
board assembly back into the enclosure.
5.
Install the four pan head screws into the corners of the
back panel and tighten.
6.
Re-install the DTR-65 into the panel using the panel
mount jacks, gasket, and set screws.
DTR-65 Re-assembly (if pulled out too far)
If the board assembly is pulled all the way out of the
enclosure, follow these steps to reinstall it without
damaging any components.
1.
Install the board assembly into the enclosure on the
second groove from the bottom.
2.
Slide the board assembly in until the keypad cable is
just flush with the back of the enclosure.
3.
Use a small screwdriver to pull the cable so it makes a
loop over the top of the header P105 on the main
board.
4.
Carefully slide the board assembly the rest of the way
into the enclosure.
continued
