3–13
INSTALLATION
www.maxcessintl.com
Fife-200 Web Guiding System
MI 1-918 1 C
Installing cables
(continued)
3.
You will need to remove hole plugs from the end plates to
connect the cables. Use the controller connection diagrams
and the markings on the end plates to determine which hole
plugs to remove.
4.
Re-use the lock nuts to install the bushings from the cables
in the appropriately marked holes in each of the end plates.
The lock nut for the power cable bushing is on the bushing.
Power entry end plate
Parallel I/O entry end plate
Figure 12. Controller
enclosure end plate markings.
Connecting earth ground (PE)
The green wire with the ring terminal from the power cable is
the protective earth connection and is labeled "PE".
It must be connected to the inside of the power entry end plate
and secured with the supplied flat head screw and nut.
Figure 13. Connecting the PE wire to the end plate.