MAXA ADVANTIX i-SHWAK V4 06, User Manual

Page: 27 / 48

i-SHWAK V4
Inverter air/water chillers and heat pumps with wall-mounted indoor unit and remote condensing outdoor unit
26
Terminal block Auxiliary Board – AB – Indoor unit
Jumper Terminal Description
CN3
HP+ N.U.
HP- N.U.
LP+ N.U.
LP- N.U.
DT DHW terminals
CN4 PWM 1 / 0-10V 1 Analog output for DHW circulator signal
CN5 PWM 2 / 0-10V 2 Analog output for plant circulator signal
CN7
12V See 12V terminals
AI10 Ratiometric 0-10V analog input
+5V Power supply for ratiometric
CN8
AI1 IMP terminals
AI2 Outlet (flow) temp. sensor
AI3 Inlet temp. sensor
AI4 DHW secondary flow sensor
CN9
AD1 DHW primay flow sensor
AD2 DHW seconday inlet temperature sensor
DI1 Flowswitch
DI2 ON/OFF terminals
DI3 SW termninals
CN10
L Single-phase 230Vac
N NU
DO1 DO1 terminal
DO2 DO2 terminal
DO3 DO3 terminal
DO4 DO4 terminal
DO5 Phase 230Vac
DO5 DO5 terminal
CN12
NC1 Normally Closed Changeover Contact
C1 Phase 230Vac
NO1 Normally Open Changeover Contact
I+ / I- I+ / I- terminals
GND GNDR terminal
R+ / R- R+ / R- terminals
E+ / E- E+ / E- terminals
CN14
NC2 NC2 terminal
C2 Phase 230Vac
NO2 NO2 terminal
For connecting the I- / I+ and GNDR terminals, t’s recommend to use a shielded twisted -pair multipolar cable 5x0.75mm
2
.
8.7.2 Outdoor unit
The connections listed below are standard. Other connections are shown in the manual MCO (Control Manual) of the control
panel of the machine i-SHWAK V4.
x
Remove the mounting screws of the cover of the power supply (see the paragraph 8.4.2.3.)
x
Connect the cable to the terminals inside the electric box.
x
For electrical connections please refer to the wiring diagrams given in the supplied MSE manual.
8.7.2.1 Terminal block connections
The terminal block must be connected in compliance with the following notes (the schema is only for illustration).
Outdoor unit terminal block
Terminal Description
GND Grounding
N1 Neutral
L1 Phase 1
L2 Phase 2 (only for three-phase systems)
L3 Phase 3 (only for three-phase systems)
NO Power supply (230V AC) general alarm (closed if the alarms is on)
N Neutral
NC Power supply (230V AC) general alarm (closed if the alarm is off)
I+ / I-
Modbus Slave
Wiring with indoor unit
R+ / R-
Modbus Master
Wiring with indoor unit
GNDR
GND reference signals
(Modbus reference mass for connection with indoor unit)