6
6
Building Your Max-Trainer
1.
For the IC version you will first have to remove the top pre lasered wooden panel to give access to
the motor bay. Peel the covering back and using a sharp modelling knife or Drexel cut away the top section
of wood following the pre lasered line. Once you have removed this section of wood you can re stick down
the film using a covering iron or travel iron. At this stage you can also cover all the exposed edges of wood
in the engine bay with 5 minute epoxy to help fuel proof the area. Also remove the film covering from the
oil drain hole under where the motor fits.
2.
Loosely install the motor mount using the M4 x 25mm Philips head bolts and washer. The mount is
adjustable in width to suit various engines. Sit your engine on the mount and mount happy with the width
tighten up the bulk head bolts.
Summary of Contents for MAX TRAINER Balsa Pro-Built Series
Page 1: ...Instruction Manual...
