13
13
Building Your Max-Trainer
3.
Centre all the servos and then connect the elevator and rudder push-rods to the servos and install.
Once in position centre the elevator and rudder and then trim the push-rods to length leaving enough rod
(8mm) to bend the end 90 degrees to go through the servo horn and secure with swing keeper, if needed
you can adjust the quick links to get the control surface level.
4.
IC ONLY
Install the throttle control rod and connect to the carburettor. Trim the remaining rod to
length to suit your servo and slide it through the rod stopper screwed to the servo horn. Adjust and tighten
when happy you have full throttle control.
1.
Rudder and elevator push-rods. Unscrew the metal quick links and slide the push-rods down the
tubes in the fuselage so that they exit to the rear of the fuselage. Reinstall the metal quick links.
2.
Install the servos of your choice, prototype used 17g Mighty Mini servos from Century UK. If building
electric version you don’t need the throttle servo. Screw the servos in to the mount and then fit this in to
the fuselage using the M2x12mm
Summary of Contents for MAX TRAINER Balsa Pro-Built Series
Page 1: ...Instruction Manual...
