SIPHON PLUG
Pull out the detergent drawer. Remove the siphon plug and clean the
residues of the softener thoroughly. Fit the cleaned siphon plug in its location.
Check if it placed properly.
THE CABINET
Clean the exterior surface of the cabinet of your machine with lukewarm water
and a cleaning substance that will not irritate the cabinet. After rinsing with
clean water, wipe it with a soft and dry cloth.
WARNING!
If the machine is installed in a location where the ambient temperature can fall
below 0
˚
C, do the following when it will not be in use:
•
Plug in the machine.
•
Close the water tap and pull out the water inlet hose or hoses from
the tap.
•
Place the ends of the water drain and water inlet hoses in a cup on
the ground.
•
Adjust the program knob to “Draining” program.
•
The program ready light will be on.
•
Run the program by pressing the start/pause button.
•
Unplug your machine when the program is over (program end light is
on).
When you complete these proces, the remaining water inside the machine will
be drained and thus formation of ice in the machine will be prevented. When
you operate your machine again, be sure that the ambient temperature is
above 0
˚
C.
THE DRUM
Do not leave metal parts like needles, staples or coins inside your machine.
These pieces cause formation of rust stains in the drum. To eliminate these
stains of rust, use a cleaning substance without chlorium and follow the
warnings of the cleaning substance producer. For cleaning of the rust stains,
never use dish-washing wires or similar rough objects.
REMOVAL OF LIME FROM YOUR MACHINE
If you arrange the amount of the detergent you use in your machine properly,
there will be no need for lime removal. However, if you desire to apply the
removal procedure, use the lime protectors in the market and pay attention to
their warnings.
WARNING!
The lime eliminating substances contain acids and this may cause colour
modifications in your clothes along with an adverse effect on your machine.
19
