••••
If you will not use your machine for a long time, unplug your machine,
close the water supply and leave the door open in order to keep the
inside of the machine dry and for prevention from unpleasant odour.
••••
As a result of the quality control procedures, a certain amount of
water may remain in your machine. This is not harmful for your
machine.
SECTION 2: INSTALLATION
You must pay attention to the following issues before using your washing
machine.
REMOVAL OF TRANSPORTATION SCREWS
••••
Transportation screws, which are located at the back side of the
machine, must be removed before running the machine.
••••
Loosen the screws by rotating counterclockwise by a suitable wrench.
(DIAGRAM-1)
••••
Remove the screws by pulling them.(DIAGRAM-2)
••••
Pull out the rubber plugs using a pair of grips.
••••
The plastic parts located in the interior part of your machine will fall
down under the device.
••••
Lift your machine up slightly, pick up the plastic parts(2 persons
recommended).
••••
If all of the plastic parts of screw groups have not fallen down; open
the door of your machine,move the drum until all plastic parts fall
down. Collect the parts that have fallen to the floor.
••••
To the holes where the transport screws have been removed, insert
the plastic transport screw taps found in the accessories bag.
(DIAGRAM-3)
••••
The transportation screws, that have been removed from the machine
should be kept in hand for any other transportation necessities.
DIAGRAM-2
DIAGRAM-1
DIAGRAM-3
ADJUSTMENT OF FEET
••••
Do not install your machine on rugs or similar surfaces.
••••
For your machine to work silently and without any vibration, it should
be settled on a flat, non-slippery and tough ground.
3
