!
34
POWER On
Function
KB Power On
Password
Hot Key Power On
The Power On Function item allows you to
power on the system by pressing hot-keys, or
typing a password. If you choose Password,
you can use the item KB Power On Password
to install a power on password. If you set it to
Hot Key, you can then use the item Hot Key
Power On to choose which hot keys are
installed.
KBC input clock
This item set the timing for the keyboard
controller input clock. Leave this item at the
default value.
Onboard FDC
Controller
Use this item to enable or disable the onboard
floppy disk drive controller.
Onboard Serial
Port1
Use this item to enable or disable the onboard
serial port COM1, and to assign a port address.
Onboard Serial
Port2
Use this item to enable or disable the onboard
serial port COM2, and to assign a port address.
UART Mode Select
This item defines the operation of serial port 2.
In the Normal setting, serial port 2 is assigned
to the external COM2 connector. If you have
installed an optional infrared port, you must
change the setting of this item to one of the
Infrared settings (usually IrDA or FIR). These
settings will disable the external COM2 serial
port connector and assign the resources to the
infrared device. If you have selected an IR
mode, two items appear, RxD, TxD Active and
IR Transmission delay, which let you set the
duplex and transmission parameters for the
Infrared port. See the documentation of your
infrared port for help on these items.
UART2 Duplex
Mode
Use this item to define if the optional infrared
port is full or half duplex.
Onboard Parallel
Port
Use this item to enable or disable the onboard
parallel port LPT1, and to assign a port
address.
Parallel Port Mode
Use this item to determine the parallel port
mode. You can select Normal, ECP (Extended
Capabilities Port), EPP (Enhanced Parallel
Port), or ECP + EPP.
