Matrox Vio, Installation And Hardware Reference

Page: 20 / 60

Installing the expanded video input adapter board 19
Installing the expanded video input adapter
board
Proceed with the following steps to install the expanded video input adapter board:
1. Ensure that your Matrox Vio Duo board is securely fastened to the computer
chassis.
Connect one end of the flat ribbon cable to the 40-pin internal connector of the
Matrox Vio Duo board. To do so, position the ribbon cable so that the red colored
stripe is on the same side as the bracket of the board. In this position, the connector
on only one end of the cable will latch properly. In addition, you should hear a
snap when the hooks of the cable’s connector latch onto the 40-pin internal
connector on the board.
2. Connect the other end of the flat ribbon cable to the 40-pin internal connector
on the expanded video input adapter board. Position the connectors so that their
triangular etchings face each other. The etchings indicate the location of pin 1.