Matrox Rapixo CL Pro, Installation And Hardware Reference, Page: 68 / 96

68 Appendix B: Technical information
• Supports extended Camera Link cables, for a cable length of up to 15 m at
85 MHz.
• Has up to 32 auxiliary signals that can be path independent or path dependent,
depending on the functionality
*
selected
*
. When path dependent, there are:
- Three TTL auxiliary I/O signals (trigger input or user input, or timer output
or user output) per acquisition path.
- One LVDS auxiliary output signal (timer output or user output) per acquisition
path.
- Two LVDS auxiliary input signals (trigger input, timer-clock input, quadrature
input, or user input) per acquisition path.
- Two opto-isolated auxiliary input signals (trigger input or user input) per
acquisition path.
• Has a PoCL LED for each input connector, to identify whether the connector is
providing power to the camera or not. Matrox Rapixo CL Pro DB and QB have
four PoCL LEDs, while Matrox Rapixo CL Pro SF and DF have two.
• Has three board status LEDs to indicate the status of each of the following: power,
firmware configuration, and PCIe (Host) slot.
*. For example, for Matrox Rapixo CL Pro DB and QB, TTL_AUX_IO_14 can be used
as a trigger input when grabbing from acquisition path 0 or 1; alternatively, you can
configure it as an output signal and route the output of Timer 2 to this signal. You can
only route timer 2 of acquisition path 1 to the TTL_AUX_IO_14 signal.