Matrox Rapixo CL Pro, Installation And Hardware Reference, Page: 14 / 96

14 Chapter 1: Introduction
Essentials to get started
To begin using your Matrox Rapixo CL Pro, you must have a computer with the
following:
• An available conventional x8 (or x16) PCIe 2.x or 3.x slot
*
.
• Processor with an Intel 32-bit or 64-bit architecture, or equivalent.
• A relatively up-to-date PCIe chipset. A chipset that supports the PCIe 2.x standard
is preferable. The list of platforms that are known to be compatible with
Matrox Rapixo CL Pro is available on the Matrox website, under the board’s PC
compatibility list.
• MIL or one of its derivatives. This software should be installed after you install
your board.
Matrox does not guarantee compatibility with all computers that have the above
specifications. Please consult with your local Matrox Imaging representative, local
Matrox Imaging sales office, the Matrox web site, or the Matrox Imaging
Customer Support Group at headquarters before using a specific computer.
Consult your software package for other computer requirements (for example,
operating system and memory requirements).
*. Note that you can also install Matrox Rapixo CL Pro in a x4 PCIe slot that has a
mechanical x8 connector; however, the maximum transfer rate between
Matrox Rapixo CL Pro and the Host is reduced by 50%.