Matrox Graphics Card – User Guide
13
4
Solution
Make sure the connection to the back of the monitor is firmly in place. This could be a 15-pin
or BNC connection.
If your monitor uses BNC input, make
sure the Red (
R
), Green (
G
), Blue (
B
),
Horizontal Sync (
HSYNC
– white or gray
wire), and Vertical Sync (
VSYNC
– black
wire) connections are firmly in place and
plugged into the correct input.
3
Cause
If your monitor uses BNC input, one or more connection settings may be incorrect.
1
Solution
Set each of your monitor RGB input and sync switches (if available) to 75 ohms, with the
sync set to “external”. These controls are usually switches on the back of your monitor.
4
Cause
If display problems occur after the startup screen of your operating system, your software
monitor settings may be incorrect.
1
Solution
Make sure correct software monitor settings are selected.
If your primary display is still usable,
see “Monitor setup”, page 6
. Otherwise, see the next
troubleshooting item.
Problem
After the startup screen, or after display settings are changed,
the screen image is garbled or unusable
(blank screen, rolling or overlapping screen images)
1
Cause
The Matrox display driver may be trying to use settings your monitor doesn’t support. This
can happen if a monitor was never selected in the software and the display resolution was
changed to one your monitor doesn’t support, or if the monitor connected to your computer
was changed without changing it in the software.
1
Solution
Windows 95/98/2000 –
1
If your primary display is unusable:
a
Windows 95/98 – Press [Ctrl]+[Alt]+[Del] twice to restart your computer.
Windows 2000 – Press [Ctrl]+[Alt]+[Del]
Æ
[Tab]
Æ
[Tab]
Æ
[Enter]
Æ
[
È
] (down
arrow)
Æ
[Enter] to restart your computer.
Bayonet Nut Connect (BNC)
2k
2k
9x
9x
NT
NT
WARNING:
If incorrect software monitor settings are applied, some monitors can be
permanently damaged. For more information, see your monitor manual.
2k
2k
9x
9x
