Matrix U3x-01, Service Manual

Page: 57 / 62

53
9.6 TV iNSTAllATioN iNSTRUCTioNS
CHAPTeR 9: Bike SPeCifiCATioNS AND ASSeMBly gUiDe
1) Remove the bracket, hardware, and TV from their boxes.
2) Pound the spring pin (found in the hardware bag) into the small hole in the TV bracket (Figure A). This is much easier to do before the
bracket is installed on the bike.
3) Remove the Matrix Logo plate from the front of the console mast (Figure B).
4) Pull the coax and TV power wires through the hole in the front of the console mast. NOTE: You may need to remove the console to get
these wires fished through the hole in the front of the console mast.
5) Attach the coax and TV power wires to the wiring running inside of the TV bracket (Figure C). You will need to use the male to male coax
connector shipped in the hardware bag (Figure D).
6) Attach the TV bracket to the console mast using the 4 screws removed in Step 3 (Figure E).
7) Attach both of the long metal pieces (called rabbit ears) to the TV bracket using the long screw and nut found in the hardware bag
(Figure F). The user's right side rabbit ear should be installed so that the spring pin lines up with a hole in the rabbit ear to limit the angle of
adjustment of the TV (Figure G).
8) Attach the TV to the rabbit ears using 4 screws from the hardware bag (Figure H).
9) Attach the TV controller bracket to the front of the console. The TV controller bracket will mount using the 2 bottom screws holding the
console to the console mast (Figure I).
10) Attach the TV controller to the TV controller bracket (Figure J).
11) Connect the TV power wire (Figure K), coax cable signal wire (Figure L), and controller wire (Figure M) to the back of the TV. NOTE: The
controller wire will have a tag on both ends, one labeled controller, the other TV.
12) Connect the controller wire to the back of the TV controller (Figure N).
13) Install the cover onto the back of the TV (Figure O). NOTE: There is an extra cover shipped with the TV.
13) Run a coax cable to the base of the bike and plug it into the entertainment port (Figure P).
14) Plug in the TV power adaptor to a wall plug and into the entertainment port at the base of the bike (Figure Q).
15) Use the remote control sent with the TV to perform a channel search to program the TV (Figure R).
16) To perform a channel search, hit MENU, the right arrow once, hit the down arrow to Auto CH Search, and then ENTER. The TV will
automatically search for both Analog and Digital channels.
figURe A figURe B