SDT 5000 User Manual
Document MBUD-0109v11
STRIP ,W,Strip message delimiter mode : NONE
RTTIME,W,RTU Time Stamp : NO
RTDATE,W,RTU Date Stamp : NO
TMODE ,W,RTU message transmission : IMMEDIATE
RTTRY ,W,RTU retry time (secs) : 20
RTHOLD,W,RTU connection hold time (secs) : 30
RTDBIT,W,RTU end to end confirmation : NO
RTFAST,W,RTU fast select : NO
RTBUF ,W,RTU buffer message : YES
RTNUM ,W,Number of RTU retries : 1
FLUSH ,W,Flushing buffer : NO
RXMAX ,W,Maximum receive message size. : 4096
BAUD ,W,RTU port baud rate : 9600
PARITY,W,RTU port parity : NONE
DATA ,W,RTU port data bits : 8
STOP ,W,RTU port stop bits : 1
RXFLOW,W,CSC bound flow control : NONE
TXFLOW,W,MET bound flow control : NONE
DCD ,W,Data carrier detect (DCD) mode : ASSERT
DSR ,W,Data set ready (DSR) mode : ASSERT
DTR ,W,Data terminal ready (DTR) mode : OFF
DEBUG ,W,Transparent protocol debug level : OFF
A description of the parameters is shown below:
Transparent Protocol
Enable
The ENABLE flag reflects the current setting of the ‘apmode’. If ‘apmode’
is set to “transparent” the ENABLE flag will be set to YES.
Destination Address
The destination address is the X25 address of the host system. You will
need to contact your system administrator or service provider to determine
what value to use.
The default value is NONE, which is not a valid X25 address. This value
prevents the RTU from sending unsolicited data to the host. The host can
still connect to the SDT 5000 and send and receive data from the RTU.
If the buffer message flag is YES any data sent by the RTU will be
buffered until the host connects.
Start of message string
The start of message string is used to delimit data sent by the RTU.
Received data is ignored until the start of message string is received. If the
start of message string is NULL then all received data is accepted.
The default is no start of message string.
End of message string
The end of message string is used to terminate a data message sent by the
RTU. If the end of message string is set to “” then the message is
terminated based on the end of message idle timer.
The default is no end of message string.
Version 1.1, 03/24/06
Page 31
