11
4.3 ASSEMBLY STEPS U1xLS
1)
Secure the
upper console mast
to the
lower console mast
using four bolts
(
Z01
). Alternately tighten each bolt using the #6 Allen Wrench. Check the
console mast to make sure it is securely fastened.
Z01
Z01
Z08
Z01
STEP 3
HANDLEBAR SET
1)
Feed the
heart rate wires
of the
handlebar
through the small hole located
in the front of the
console mast
. Pull these wires up through the hole at
the top of the
console mast
. Attach the
handlebar
to the
console mast
using four bolts (
Z01
). Tighten with the #6 Allen Wrench (
Z31
).
CONSOLE
1)
Remove the four mounting bolts from the back of the
console
with the
Phillips Screwdriver (
Z33
). Plug in the wire harness and the two heart rate
wires to the back of the
console
. Attach the
console
to the
console mast
with the four bolts removed earlier in this step.
ACCESSORY TRAY
1)
Attach the
accessory tray
to the
console mast
using two screws (
Z08
).
Tighten them with the Phillips Screwdriver (
Z33
).
Z01
Z01
Z08
Z01
STEP 4
CHAPTER 4: B
ike
p
arts
and
a
ssembly
G
uides
R1xLS_U1xLS_r1.2.indd 11
3/18/10 4:23 PM