Rev.
Descrizione
Redatto/Gestito
Approvato
Cod.Ident.
Pagine
Data Em.
0.6
Manuale Istruzioni
GN
UTEC
B041.M01.EN
39
/47
07/2014
8.03
EXTRAORDINARY MAINTENANCE
For extraordinary maintenance operations refer directly to the Manufacturer.
8.04
AUTHORISED MAINTENANCE CENTRES
For information on the nearest authorised help centre it is essential to contact the manufacturer.
Chapter 9
GUIDE TO RECOGNISING DAMAGE AND ANOMALIES
This chapter presents and discusses all the simple problems which could occur during machine use.
The appropriately qualified, professional personnel must carry out all the maintenance procedures, check and control, as well
as all the repair operations on parts of the machine or the electrical system.
Contact Technical Sales Assistance for any other problem not listed on the previous table or should the malfunctioning persist
after the intervention of the operator in accordance with the previously mentioned courses of action.
PROBLEM
POSSIBLE CAUSE
REMEDY
After activating the main switch, the roller
compactor does not turn on (the tension light is
off)
No power supply
Check that the electric cable is not damaged
and well connected to the power source Il
Check the external safety devices of the
electrical system
Check that the roller compactor main switch
works properly.
The electric system is
damaged
Contact the technical assistance service
The compactor is on, but the display is off (the
tension light is on)
The electric system is
damaged
Contact the technical assistance service
During the equipping phases – mould positioning,
compaction test execution – the programm
activates the functions, but the cart - or the roller –
does not work in accordance to them.
The test parameters are
wrong
Check if the parameters have been set correctly.
In the calibration phase of the load exerted
by the piston of the machine, there is a value
excessively imprecise.
Excessive friction
within the pneumatic
chamber of the piston
Temporarily disconnect the air supply and
remove the rear cover of the machine.
Through the connection of supply air of the
pneumatic cylinder, placed in the top flange,
insert grease.
Chapter 10
SPARE PARTS
WARNING
DANGER
Only original spare parts can be used.
Use of unoriginal spare parts exempts the manufacturer from all
responsibility. Procedures for substitution of spare parts will be provided by
the manufacturer along with the part. For spare parts contact the
manufacturer’s Sales Service department.
Chapter 11
INACTIVITY
ì
Ensure all machine parts are in safe working order before operating it again should the machine be inactive for a long period of
time. When in doubt contact the Manufacturer.
Chapter 12
DECOMMISSIONING THE MACHINE
Should it be decided that the machine is to be no longer used, proceed as follows:
•
Disconnect the electrical supply network by removing the connecting cable therefore making it unusable.
•
Make the potential sources of danger harmless, such as sharp or protruding parts.
•
Dismantle the machine; divide it into similar parts and dispose of according to the standards in force
Recycling notice for the disposal of electrical and electronical devices
This symbol, shown on the device or on the package and/or the documentation, suggests that the
device should not be disposed together with other home garbage at the end of its life cycle.
To avoid further environment, or health-care damage, caused by the unsuitable disposal of garbage,
the user should separate this device from other different types of garbage and recycle it in
responsibly to avoid the reuse of material resources. Users must take care at the disposal of the
equipment by taking it to the nearest recycling site for appropriate recycling treatment for electrical and
electronical devices. Gathering and Recycling deplete devices allow the preservation of natural resources and
grant them the adequate treatment by respecting health and environment.
For further information on your local recycling site please contact your local council or city waste treatment
department. The developer, as producer of electrical and electronical devices, will provide to finance the recycling
